Don’t interpret incorrectly thinking that small means "not as tough". There are a world of applications that have a target height that is one-half or less of normal dock height. When your high side is 33" or less you might consider this economical solution.
With the optional mobility package the Mini does not need the hydraulic actuated under- carriage to move it to the work. Two screw jacks with rigid steel casters are mounted at the balance point and a couple of people can move it on a hard surface. Floor plate approach both top and bottom insure a long life on the grating whether you are using manual equipment or forklift trucks.
Capacities start at 12,000# and go up from there. Widths of 70" & 84" and lengths starting at 15’. Call for special sizes and capacities.
Mini Ramp shown with Screw Jack option.
Features for Mini Loading Ramps
•Curb design same as Full Size Ramp • 8" of curb above drive surface • Steel Diamond Deck Approach Plates (top & bottom) • Serrated steel grating for traction & self cleaning • Capacities from 12,000 lbs to 60,000 lbs
Options for Mini Loading Ramps
Mobility package – use the wheels to move the ramp into position. The hand cranks rotate 90 degrees and self store.
STEEL MINI RAMPS MODEL MR
Mini ramps are a smaller version of a yard ramp. Used for dock to ground applications where the dock is 18-32" high. Typically for fork lift use.
Order Online
Click the button of the item you wish to purchase.
1. Remove any and all shipping rigging (i.e. straps, clamps, chains, etc.). 2. Using a lifting strap, wrap around the lift lug located on the top side. 3. Lift unit off the truck. 4. Have truck drive out from under the raised unit if possible. 5. Lower unit onto ground surface. 6. Tilt the ramp unit such that it will be laid over slowly using the lift. 7. Attach the screw jacks to both sides and raise the unit before moving.
Shipped right side up:
1. Remove any and all shipping rigging (i.e. straps, clamps, chains, etc.). 2. Using lifting straps, lift the unit from four points so that the unit will be lifted in the same position. 3. Have the truck move out from under the suspended unit. 4. Slowly lower the unit onto surface. 5. Attach the screw jacks to both sides of unit and raise the unit. 6. Manually move the unit into position.
CLOSED TRUCK OR CONTAINER
Shipped right side up:
1. Remove any restraining equipment. 2. Raise the unit. 3. Attached the screw jacks (if purchased). 4. Raise the unit with the screw jacks until the unit is off the ground. 5. Manually push the unit out of the truck/container. 6. Move to position.
CAUTION: These instructions are strictly a suggested method to unload your equipment by the manufacturer. Personnel unloading should consider all safety practices to safely unload the unit. Also, when the unit is in use, the unit should be secured and screw jacks completely raised off the ground surface.
Mini-Ramp, Mobile Yardramp, Mobile Yardramps, Portable Yardramp, Portable Yardramps, Steel Yardramp, Steel Yardramps, Yardramp, Yardramps, Fork Lift Ramp, Portable Fork Lift Ramps, Forklift Ramp, and Portable Forklift Ramps from your complete source for material handling equipment.
