NO
TOOLS REQUIRED FOR HANGING STRIPS
MAXBULLET STRIP DOOR HARDWARE
Superior quality strips require world class hardware. State-
of-the-art MaxBullet technology features a bullet shaped
locking system for easy snap on/snap off strip installation.
The combination of Clear-Flex® II strips with MaxBullet
hardware creates the most time-saving and energy-efficient
strip door solution on the market.
Reduce installation
time by 75%
Reduce replacement
strip time by 90%
Pair MaxBullet with
Clear-Flex II strips for
the ultimate strip door
installation
Hi-Viz®
Fluorescent Safety Rings are placed on
the studs of the MaxBullet® hardware to indicate
the top of the door opening in low light conditions.
Order Online
Click the button of the item you wish to purchase.
MaxBullet
Truck Mount System Installation Instructions
PARTS
INCLUDED:
TOOLS
NEEDED:
1) 8 ft. MaxBullet Mounting Bar (2) L-brackets (4) 1/4"
x 1 1/2" Self-Tapping Screws (4) 1/4"
x 3/4" Bolts (4) Locknuts Scratch-Guard
Material & Hi-Viz
Safety Rings*
Pen or Pencil Drill with
1/4" Bit Adjustable
Wrenches Saw (as
needed) Ladder Tape Measure Utility
Knife
*
Number of strips and safety rings dependent upon strip size
and overlap
INSTALLATION
Figure
B
Figure
C
Figure
A
Step
3 Measure width of trailer
and, if necessary, cut mounting bar
to length using saw.
Step
2 Using the self-tapping screws
provided, install L-bracket on stud
as close to roller track as possible
without impeding movement of door
on track. Repeat for other side.
Step
1 For trailers with roll-up
doors, locate the stud closest to
the door opening in the rear of the
trailer.
Step
4 Place mounting bar on
L-brackets and using L-bracket
as a template, mark holes and drill
with a 1/4" drill bit.
NOTE:
For trailers with swing
doors, mount bar as close to top of
trailer as possible. Be sure to leave
room for mounting bar and bolts,
approximately 1" from top.
NOTE:
Remember to leave
room for mounting bar.
Figure
D
Figure
E
Figure
F
Step
5 Mount bar to L-brackets
using the provided bolts and
locknuts.
Step
6 Install PVC strips using
preferred amount of overlap. Refer
to diagram on bottom of this
page for details on strip placement
Step
7 Place Hi-Viz safety rings
on bullets where strips overlap
(see Figure F).
Step
8 The strips should be trimmed
to leave 1/4" of clearance from the
floor surface. Use a common utility
knife to score and then tear
the strips by hand.
STRIP
PLACEMENT GUIDE
PARTIAL
OVERLAP
FULL
OVERLAP
6"
WIDE
MATERIAL
8"
WIDE
MATERIAL
12"
WIDE
MATERIAL
MaxBullet, Aleco
Strip Doors, Plastic Strip Door, PVC Strip Door, Strip Door,
Strip Doors, Vinyl Strip Door, Welding Strip, Truck
Mount Strip Door, Insect Barrier, and Traffic Doors from your
source for material handling equipment.
Reduce installation
1) 8 ft. MaxBullet Mounting Bar
